Claresa Basecoat Ultra 5ml

is a hardening, transparent base coat with a high content of polymers that guarantee the hardness of diamond. Create long and strong nails with the Ultra Basecoat. Due to the thick consistency, it is possible to carefully build the nail and even extend by 10 mm. The Ultra Basecoat is enriched with a high level of polymers that make the nails extra strong and as hard as diamonds. This also makes the Ultra Basecoat suitable as a gel base. The Claresa Basecoat is recommended for shorter nails. Density: 5/5 Use: Apply the basecoat to a matted and degreased nail plate. Apply in thin layers and hard under a UV/LED lamp. Maintains 120 seconds of hard time with a UV lamp and 30 seconds with an LED lamp. Then apply a layer of gellak in a color of your choice and hard it. Finish with a topcoat and hard it also under the UV/LED lamp. Read the full user manual and instructions for removing gellak at the bottom of this page. Plus and downsides hardening transparent base coat for manicures makes the nails as hard as diamond by polymen thick consistency is suitable for the nails to be built up to 10mm possibly also suitable as a gelbase, the adhesion of the nail polish quickly increases under a UV/LED Lamp, STEP 1 usage instructions for use, The natural nails with a polishing block, step 3: Push the cuticles back with a goat boat and possibly remove them with a cuticle tongs, step 4: Clean the nails and dust -free with a cleaner and wait until the nails are dry, Step 5: apply a thin layer of primer to the nails. Wait until it is dry, this takes about 30 seconds, step 6: apply a thin layer of base coat and hard the nails under a lamp. Depending on the Basecoat 30-60 seconds under an LED lamp and 2-3 minutes under a UV lamp, step 7: Apply one thin layer of the hybrid gellak and hard the nails under a lamp. 30-60 seconds under an LED lamp and 2-3 minutes under a UV lamp, step 8: If desired, apply a layer of hybrid paint and repeat the above step until the desired coverage is reached, step 9: apply a topcoat and hard the nails under the lamp. 30-60 seconds under an LED lamp and 2-3 minutes under a UV lamp, Step 10: Then clean the nails with a cleaner to remove the sticky layer, step 11: Massage the skin around your nails as extra care with a caring nail cream or cuticle oil. Note: More pigmented colors, such as black and white, may require a longer curing time. It is important to apply these layers thinly and, if necessary, to paint and harden a second time to achieve the desired coverage. Removing the Claresa UV/LED Hybrid Soakoff Gel nail polish: Step 1: Carefully file the topcoat off the nails, Step 2: Soak a cotton pad in nail remover and place the cotton ball on the nails, Step 3: Make sure that the nail plate is completely covered. You can use nail remover foil for this. Wrap your finger firmly here, step 4: Check after a few minutes if the paint is loose. If this is not the case, wait a little longer, step 5: When the gellak is released, remove the remains with an Orange Woodstick, step 6: After removing, use a hand cream and a cuticle oil for the optimum care of the hands. Ingredients: Di-Hema Trimethylhexyl Dicarbamate, HydroxyPropyl Metacrylate, Hema, Isobornyl Metacrylate, HydroxyCyclohexyl Fenyl Keton, CI 60725. This article is only for professional use and can cause an allergic reaction.