Claresa Basecoat 5ml

Forms a perfect, transparent basis for every manicure. The Basecoat increases the adhesion of the paint to the nail plate and will considerably extend the life of a manicure. The base coat has a medium thick consistency, making it easy to apply and does not run over the cuticles. This makes use very easy. The Basecoat leaves a sticky dispersion layer. The Claresa hybrid gellak attaches extra good to this and can also be applied immediately nail decoration such as glitter powder. The Claresa Basecoat is especially suitable for styling on short nails. The Basecoat Ultra is recommended for long nails or nail provision. Density: 3/5 Use: Apply the basecoat to a matted and degreased nail plate. Apply in thin layers and hard under a UV/LED lamp. Maintains 120 seconds of hard time with a UV lamp and 30 seconds with an LED lamp. Then apply a layer of gellak in a color of your choice and hard it. Finish with a topcoat and hard it also under the UV/LED lamp. Read the full user manual and instructions for removing gellak at the bottom of this page. Plus and minus points Perfect Basecoat For Manicures for short nails Medium thick consistency does not spread easily does not run over the cuttings. A sticky dispersion layer behind the adhesion of the nail polish quickly drained under a UV/LED lamp Suitable for nail decoration: Make the Negelig Dispersie Layer in Dispersie layer Shape, Step 2: Remove the shine from the natural nails with a polishing block, step 3: Push the cuticles back with a goat boat and possibly remove them with a cuticle tongs, step 4: Clean the nails and dust -free with a cleaner and wait until the nails are dry, Step 5: apply a thin layer of primer to the nails. Wait until it is dry, this takes about 30 seconds, step 6: apply a thin layer of base coat and hard the nails under a lamp. Depending on the Basecoat 30-60 seconds under an LED lamp and 2-3 minutes under a UV lamp, step 7: Apply one thin layer of the hybrid gellak and hard the nails under a lamp. 30-60 seconds under an LED lamp and 2-3 minutes under a UV lamp, step 8: If desired, apply a layer of hybrid paint and repeat the above step until the desired coverage is reached, step 9: apply a topcoat and hard the nails under the lamp. 30-60 seconds under an LED lamp and 2-3 minutes under a UV lamp, Step 10: Then clean the nails with a cleaner to remove the sticky layer, step 11: Massage the skin around your nails as extra care with a caring nail cream or cuticle oil. Note: More pigmented colors, such as black and white, may require a longer curing time. It is important to apply these layers thinly and, if necessary, to paint and harden a second time to achieve the desired coverage. Removing the Claresa UV/LED Hybrid Soakoff Gel nail polish: Step 1: Carefully file the topcoat off the nails, Step 2: Soak a cotton pad in nail remover and place the cotton ball on the nails, Step 3: Make sure that the nail plate is completely covered. You can use nail remover foil for this. Wrap your finger firmly here, step 4: Check after a few minutes if the paint is loose. If this is not the case, wait a little longer, step 5: When the gellak is released, remove the remains with an Orange Woodstick, step 6: After removing, use a hand cream and a cuticle oil for the optimum care of the hands. Ingredients: Di-Hema Trimethylhexyl Dicarbamate, HydroxyPropyl Metacrylate, HEMA, Isobornyl Metacrylate, HydroxyCyclohexyl Fenyl Keton, CI 60725. This article is only for professional use and can be an allergic reaction cause.