The FAHRER Motor Cover is a quality product made to protect the motor of an e-bike during transport on the roof or on a luggage carrier mounted on the tow bar or tailgate. If you want to take your e-bike on holiday, it is often transported in or on a vehicle. Attached to the roof or luggage rack, the bicycle is exposed to driving rain and splashing water while riding, which can penetrate into the engine due to the high impact pressure on the housing. The MOTOR COVER PREMIUM, made of high-quality, elastic neoprene, protects the motor of your e-bike during transport against weather influences, such as driving rain and stone chips. This guarantees the long-term operation of the engine. The elastic material of the COVERS allows precise adjustment to mid-motors from different manufacturers: Please note: The Motor Cover is a transport protection and must be removed before cycling. The Motor Cover is not intended to keep the motor housing dry. The holes in the bottom of the cover drain rainwater. If cleaning is necessary, we recommend washing it by hand with a mild soap. Features: suitable for any mid-motor e-bike such as BOSCH, SHIMANO, IMPULSE, YAMAHA, BROSE, TranzX and PANASONIC can be adapted to individual frame and motor geometry. Properly mounted it will fit tightly around your bike and frame and won't cause scratches like loose bags in the airflow while riding. The Motor Cover is a transport protection (must be removed before cycling) and is not designed to keep the motor housing dry. Material: high quality neoprene. Easy to assemble. Variable pedal position possible, left or right forward and approx. 45 degrees up or down to adapt to the rear rack. Fits all mid-motor e-bikes such as BOSCH, SHIMANO, IMPULSE, YAMAHA, BROSE, TranzX and PANASONIC. Designed in Berlin and produced in the EU. Installation: Place the MOTOR COVER on the motor from the chain/toothed belt side with the Velcro fasteners open. Place the large tab around the bottom of the motor and fold it over to the other side of the motor. Attach the flap with the Velcro fasteners. Finally, thread the top flap with the rider's logo between the down tube of the frame and the engine, pull tight and close with the Velcro closure.